Livarno 103745-14-01-BS/103745-14-02-BS - Manual (Page 5)

5 GB
a risk of suffocation if children play with the packaging material. Children often
underestimate risks. Always keep children away from the packaging material.
This product is not a toy.
J This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of experi-
ence and knowledge if they have been given supervision or instruction con-
cerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user mainte-
nance shall not be made by children without supervision.
J This product is not a toy and should be kept out of the reach of children. Children
are not aware of the dangers associated with handling electrical products.
J Do not use the article if you detect any kind of damage.
J CAUTION! DANGER OF EXPLOSION! Do not operate the
LED work lamp in potentially explosive environments in which there
are inflam mable vapours, gases or dusts.
J Protect the appliance from moisture and damp. Never immerse the device in
water or other liquids!
J Connect the LED work lamp to a properly installed mains socket or a suitable
cigarette lighter socket only. The voltages in each case must comply with infor-
mation given in the section “Technical data”.
J Ensure that the electrical socket is easily accessible so that you can pull the plug
quickly out of the socket if necessary.
J Do not carry out any modifications or repairs to the product yourself. The LEDs
cannot and must not be replaced.
CAUTION! The protective surround to the LEDs cannot be replaced. Dispose
of the LED work lamp if you discover cracks or signs of fracture on the protective
surround.
J Dispose of the product if the LED work lamp, mains adapter or car adapter is
damaged.
J Never connect the LED work lamp to a power supply socket if the LED work
lamp, power lead or socket is damaged or the LED work lamp has been
dropped.
J Ensure that the power lead cannot become damaged by sharp edges or hot
objects. Unwind all the lead completely before use.
J Keep easily flammable materials away the product. Never hang objects above
the LED work lamp or the mains adapter and never cover them.
J Pull the mains adapter / plug out of the mains socket / cigarette lighter socket
when you are not using the LED work lamp or before you clean it. Do this as
well if signs of a fault develop during use or charging, e.g. smoke, burning
smell etc., or during a storm. When doing this, pull directly on the mains
adapter / plug and not on the lead.
J Protect the product against heat, cold, strong vibrations and impacts.
Q
Before use
Q
Charging the LED work lamp
Note: You can charge the LED work lamp 6 from an ordinary domestic mains
power outlet or from the cigarette lighter socket in your vehicle.
Note: The fuse of the car adapter is replaceable. The specification must comply
with information given in the section “Technical Data”. The fuse may only be replaced
by a qualified electrician (see Fig. B).
Tip: We recommend that you charge the LED work lamp from an ordinary
domestic mains power outlet to avoid draining your vehicle’s battery.
CAUTION! Do not connect the LED work lamp to the cigarette lighter socket of
your vehicle if the vehicle battery is old or degraded. Failure to observe this advice
may result in your vehicle’s engine not starting.
Note: To use the LED work lamp without an adapter, you must first charge the integral
rechargeable batteries. It takes between 5 and 7 hours to charge the integral
batteries. The rechargeable batteries are permanently installed in the base of the
LED work lamp.
Note: Charge the LED work lamp for approximately 12 hours before first use.
Note: The inspection light cannot be used during the charging process.