Livarno 1321-012L or 1322-022L - Manual (Page 5)

5 GB
Introduction / Safety
LED Floor Lamp
Introduction
Congratulations on your new product.
You have selected a high quality product.
Please be sure to carefully read the com-
plete operating instructions. Fold out the page with
the illustrations. These instructions are part of the
product and contain important information on setup
and handling. Always follow all safety instructions.
Before using this product for the first time verify the
correct voltage and that all parts are properly in-
stalled. Should you have any questions or you are
unsure about operating the product, please contact
the dealer or service centre. Please keep these in-
structions in a safe place and pass them on third
parties as applicable.
Intended use
This light is only suitable for indoor use in dry and
enclosed spaces. This product is intended for private
household use only.
Scope of delivery
Check immediately after unpacking that the parts are
complete and that the product is in proper condition.
1 Floor lamp, model 1321-012L or 1322-022L
1 Base
1 Chrome plating
1 Tool
1 Instructions for use
Parts description
1 Reflector
2 Lamp arm
3 Fixing lever
3a Locating screw
4 Stand tube
4 a Upper support tube
4 b Lower support tube
5 Mains cable
6 Base
7 Adjustment lever (model 1322-022L)
8 Chrome plating
9 Plain washer
10 Nut
11 Tool
12 ON / OFF switch
Technical Data
Model no.: 1321-012L or 1322-022L
Operating voltage: 230–240 V∼ 50 Hz
Lamp:
1 LED module about 6 W
(1321-012L) (LED not
replaceable)
2 LED module, each about
5 W (1322-022L) (LED not
replaceable)
Protection class: II /
Safety
Safety information
Damage due to failure to comply with these operat-
ing instructions will invalidate the guarantee! We
assume no liability for consequential damage! We
assume no liability for material damage or personal
injury due to improper handling or failure to comply
with the safety instructions!
Avoid the risk of fatal injury
from electric shock
Check the light for damage every time before
you use it. Never use the light if it shows any
signs of damage.
CAUTION! A damaged light means danger
of death from electric shock. In the event of
damage, repairs or other problems with the light
please contact the service centre or a qualified
electrician.