Livarno LDL 9 A1 - Manual

DISCO BALL LDL 9 A1
These operating instructions are a component of the Disco Ball LDL 9 A1 and
provide you with important information on the intended use, safety, connection
and operation of the Disco Ball. Read these operating instructions carefully be-
fore using the appliance for the fi rst time and preserve them for later reference.
Pass them on, with the appliance, to any future owner.
Intended use
This Disco Ball is intended exclusively for decorative purposes in a private house-
hold. This appliance is not intended for illumination purposes, for commercial or
industrial applications or for use outdoors. This appliance is not intended for any
other use or for uses beyond those mentioned, and they could lead to damage.
The manufacturer assumes no responsibility for damage caused by failure to
observe the instructions, improper use, inappropriate repairs, making unauthorized
changes or for using unapproved replacement parts.
Safety instructions
For safe handling of the appliance, observe the following safety information:
Connect the power adapter only to a correctly installed mains power socket ■
whose voltage matches that given in the technical specifi cations of the adapter.
The mains power plug must always be easily accessible, so that in the event ■
of an emergency the appliance can be quickly disconnected from the mains
power supply.
Ensure that neither the Disco Ball nor the power adapter come into contact ■
with water or other liquids. There is a risk of electric shock! Use the Disco-
ball only in dry indoor areas, not outdoors.
Immediately disconnect the power adapter from the mains power socket if ■
the Disco Ball does not function faultlessly or there is visible damage to the
power adapter. Then arrange for the appliance to be checked by Customer
Services.
After use or during extended absences, ALWAYS remove the power adapter ■
from the mains power socket. Otherwise, the power adapter remains “live”
for as long as it continues to be connected to the mains power socket. Thus
it also consumes energy.
Use only the supplied power adapter (Model: QM-2301206-IP20), other ■
models are possibly not suffi ciently safe or are unsuitable for the Disco Ball.
When the Disco Ball is in use, ensure that it hangs completely free and will ■
not be blocked or covered by anything. This would lead to a build-up of heat.
DO NOT hang the Disco Ball over infl ammable objects, especially not over ■
decorations, curtains or drapes. This would increase the risk of fi re!
Lay the cable from the power adapter to the Disco Ball such that no one can ■
trip over it and/or that the Disco Ball can be pulled down.
This appliance is not intended for use by individuals (including children) ■
with restricted physical, physiological or intellectual abilities or defi ciences
in experience and/or knowledge unless they are supervised by a person
responsible for their safety or receive from this person instruction in how the
appliance is to be used. Children should be supervised to ensure that they
do not play with the appliance.
Technical data
Power supply unit QM-2301206-IP20
Input 230 V ~ 50 Hz, 50 mA
Output 12 V ~ , max. 500 mA
Protection Class II /
Disco Ball LDL 9 A1
Ball diameter approx. 20 cm
Weight approx. 830 g (incl. power adapter)
Operating
temperature
+ 5°C – + 40°C
Items supplied
Before taking the appliance into use, check that all items are complete/available
and free of visible damage. If the contents are incomplete or are damaged due
to defective packaging or transportation, contact the Service Hotline (see the
chapter “Warranty and Service”). Remove all packaging material from the
appliance.
Disco Ball ▯
Power supply unit ▯
3 Screws ▯
3 Plugs ▯
4 Adhesive tapes with spare mirrors (20 pieces) ▯
This operating manual ▯
Operation
Completely unwind the cable of the power adapter. ▯
Insert the connection plug of the power adapter into the connection socket ▯
on the Disco Ball, then insert the plug of the power adapter into a mains
power socket.
The Disco Ball begins to slowly rotate and it is illuminated by the coloured
▯
LEDs in the ceiling mount.
To turn the Disco Ball off , remove the power adapter from the mains power
▯
socket.
Assembling the ceiling mount
CAUTION
Check to ensure that no pipes or electric cables are located at the drilling ►
site. There is a risk of electric shock!
In cases of frequent use, it is sensible to affi x the Disco Ball fi rmly to the ceiling.
If you only want to use the Disco Ball occasionally, you can fold out the bracket
on the ceiling mount and hang it from a hook.
Fixed installation (see Fig. 1)
Hold the ceiling bracket at the location where you wish to install the Disco ▯
Ball, and mark the three drilling holes.
Drill the holes for the plugs.
▯
Attach the ceiling bracket to the ceiling with the plugs and screws. ▯
Hanging by the bracket (see Fig. 2)
If you want to secure the Disco Ball with a hook, mark a drilling hole. ▯
Drill the hole for the plug.
Screw the hook (not supplied) into the plug.
▯
Fold out the bracket on the ceiling mount and hang the Disco Ball up from it. ▯
If you want to hang the Disco Ball from a pre-situated hook, ensure that the ▯
hook has suffi cient capacity to bear the weight. Additionally, ensure that the
Disco Ball can rotate without hindrance.
If possible, also attach the cable of the power adapter to the ceiling so that
▯
it does not hang down onto the rotating Disco Ball.
Fig. 1: Assembly of the ceiling bracket with plugs
Fig. 2: Assembly of the ceiling bracket with a hook
Cleaning and care
CAUTION
First, disconnect the power adapter from the mains power socket and the ►
connector plug from the connector socket. Failure to do so brings with it
the risk of a potentially fatal electric shock should you come into contact
with electrical parts, or if moisture permeates the appliance.
Use a soft and lint-free cloth for cleaning. ▯
Do not use aggressive or abrasive cleansers, they could damage the plastic ▯
surfaces.
The Disco Ball is maintenance free.
Store the Disco Ball in a dry environment.
Disposal
Do not dispose of the appliance in your normal
domestic waste. This product is subject to the provisions
of European Directive 2002/96/EC.
Dispose of the appliance through an approved disposal centre or
at your community waste disposal facility. Observe the currently
applicable regulations. In case of doubt, please contact your
waste disposal centre.
Dispose of all packaging materials in an environmentally friendly
manner.
Warranty and Service
You receive a 3-year warranty for this appliance as of the purchase date.
This appliance has been manufactured with care and meticulously examined
before delivery. Please retain your receipt as proof of purchase. In the case of
a warranty claim, please make contact by telephone with our service depart-
ment. Only in this way can a post-free despatch for your goods be assured.
The warranty is valid only for material or manufacturing defects not, however,
for transport damage, wear and tear or for damage to breakable parts, i.e.
switches or rechargeable batteries. This product is for domestic use only and is
not intended for commercial applications.
In the event of misuse and improper handling, use of force and interference not
carried out by our authorized service branch, the warranty will become void.
Your statutory rights are not restricted in any way by this warranty. The warranty
period will not be extended as a result of repairs eff ected under warranty. This
applies also to replacement and repaired parts. Damage and defects present
at the time of purchase must be reported immediately after unpacking or, at the
very least, two days after date of purchase. Repairs eff ected after expiry of the
warranty period are subject to charge.
Service Great Britain
Tel.: 0871 5000 720 (£ 0.10/Min.)
E-Mail: [email protected]
IAN 67216
Service Ireland
Tel.: 1890 930 034
(0,08 EUR/Min., (peak))
(0,06 EUR/Min., (off peak))
E-Mail: [email protected]
IAN 67216
Importer
KOMPERNASS GMBH
BURGSTRASSE 21
44867 BOCHUM, GERMANY
www.kompernass.com
ID-Nr.: LDL9A1-04/11-V1
- 1 - - 2 - - 3 - - 4 -
4
IB_67216_LDL9A1_LB4.indd 1 IB_67216_LDL9A1_LB4.indd 1 24.05.2011 12:03:44 Uhr 24.05.2011 12:03:44 Uhr