Livarno 3940/052L - Manual (Page 7)

7 GB
Safety / Preparation
the non-observance of these operating instructions!
No liability is accepted for consequent damage!
No liability is accepted for damage to property or
persons caused by improper handling or non-
observance of the safety advice!
To avoid danger to life
from electric shock
  Ensure that a qualified electrician or a person
trained to carry out electrical installations
performs the electrical installation.
  Every time before connecting the lamp the mains,
check it and the mains lead for damage. Never
use your light if you find it is damaged in any way.
CAUTION! A damaged mains lead presents
a serious danger to life from electric shock. In
the event of damage, repairs or other problems
with the lamp please contact the service centre
or an electrician.
  Before installation, remove the fuse for this
circuit or switch off at the circuit breaker
(0 setting) in the fuse box.
  Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (230–240 V ∼).
  Never let the lamp come into contact with
water or other liquids.
  Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing
can lead to a serious danger to life from
electric shock.
  Do not install the lamp on a moist and
conductive surface!
To avoid danger of
fire and injury
RISK OF INJURY! Check every bulb and
lampshade for damage immediately upon
unpacking.
  Do not fit the light if the bulbs and / or lamp-
shades are faulty. If they are, contact the ser-
vice point for a replacement.
  RISK OF INJURY FROM BURNS!
Ensure the lamp has been switched
off and allowed to cool before you
touch it. In this way you will avoid the danger
of burns. Bulbs give off a lot of heat around the
top of the lamp.
  Allow the lamp to cool down completely.
  Replace any faulty bulbs with new ones immedi-
ately. Before replacing the bulb, always remove
the fuse or switch the automatic cutout off.
 
0.5 m
FIRE HAZARD! Fit the light so that
it is at least 0.5 m away from the
material illuminated. Fire can result
from the development of too much heat.
  Do not allow the lamp or the packaging materials
to lie around unattended. Plastic film or bags,
Styrofoam etc. can turn into dangerous toys for
children.
Working safely
  Use 220–240 V ∼ energy-saving bulbs with an
E14 fitting and a maximum power output of
9 watt only.
  Fit the light in such a way to ensure it is protected
from damp and dirt.
  Make careful preparations for the assembly and
take sufficient time. Clearly lay out all components
and any additional tools or materials that might
be required so that they are readily to hand.
  Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.
  Preparation
  Required tools and materials
The tools and materials mentioned are not included
in the delivery. The details and values given are
non-binding and for guidance only.
The nature of the material depends on the individual
circumstances on site.