Livarno Z32102A - Manual (Page 34)

34 GB/MT
Function
The solar cell 5 converts energy from sunlight into electricity. It charges the recharge-
able battery inside the battery compartment 8 through the connected power cable.
The battery stores electric energy supplied by the solar cell. In summer, completely
drained batteries take about 2 to 4 days to fully recharge in good sunlight. The
battery must be charged before using the light for the first time (see „Charging“).
Start-up
Mounting the light
The LED solar light is preassembled and ready for use at the time of delivery. Using the
included ground spike the LED solar light can also be placed in flower beds, lower
boxes or near pathways as accent lighting. To do so, insert the ground spike 3 into
the designated holder on the underside of the light base 2 .
Remove the lamp shade 1 by lightly pulling it off the base 2 . The battery
compartment 8 is located inside the lamp shade 1 .
First press one of the two plastic straps in the direction of the ON / OFF switch 6 .
Then press the other plastic strap and carefully pull out the battery compartment
unit.
Open the battery compartment in the direction of the arrow (see fig. F).
63018_livx_A_LED-Solarleuchte_content_ES.indd 34 21.05.14 15:36