Livarno LED Tube Light - Manual (Page 14)

14 GB
Safety / Installation notices
The LED tube cannot be repaired. If the LED
tube is damaged, the product must be dis-
posed of.
Remove the fuse or switch off the circuit breaker
in the fuse box before installation. Set the light
switch to the „OFF“ position.
Verify the mains voltage on site corresponds
with the operating voltage required for the light
(220–240 V∼) before installation.
Only use the individual parts supplied, other-
wise all warranty claims will become invalid.
Only operate the LED tube with the included
LED blind starting electrode.
Protect the LED tube from moisture. Never
allow the LED tube to come into contact with
water or other liquids.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Not suitable for direct current!
When replacing conventional fluorescent lights
with LED lights, check for possible regulations
on the illuminance required which may apply.
Do not look directly into the light source
(LED mp).
The LED tube is not suitable for dimmer- or
electric switches.
Not suitable for electronic ballasts!
The total energy efficiency and light distribution
of your lighting system depends on the con-
struction of the system.
Installation notices
The LED tubes are suitable to directly replace fluo-
rescent tubes with starting electrodes. Only operate
the LED tube
5 with the included LED blind
starting electrode 4 .
Note: Note suitable for electronic ballasts!
LED tubes are suitable for lamps with single- or twin
circuit:
twin circuit replacement
Single circuit before conversion
Single circuit after conversion
Ballast
Ballast
Fluorescent tube
LED tube
Starting electrode
Blind starting electrode
230 V∼
230 V∼
twin circuit replacement
Twin circuit before conversion
Twin circuit after conversion
Ballast
Ballast
Ballast
Ballast
230 V∼
230 V∼
Fluorescent tube
Starting electrode
Blind starting electrode
LED tube
Fluorescent tube
Capacitor
Capacitor
Starting electrode
Blind starting electrode
LED tube
Remove the starting electrode 3 and replace
it with the included LED blind starting electrode
4 .
Note: Not suitable for lights with tandem circuits