Livarno Z31043-BS - Manual (Page 6)

6 GB/IE
Use
Before first use, screw the supplied bulb 2 into
the lamp fitting. When doing this check that the
bulb is firmly and securely seated.
Set up the lamp on a horizontal, even surface.
Insert the mains plug
4 into the mains socket.
Press the On / Off 16 in-line switch to switch
on the light 1 .
Remove the battery insulation strip from between
the battery 7 and the battery compartment 5
of the remote control handset 3 .
Press the I button 9 to switch on the colour-
changing lamp.
Select the desired mode using the buttons 10 – 15
(see Fig. C):
– Set the brightness by using one of the five
different brightness buttons 10 .
Note: The brightness buttons cannot be
used in the automatic colour change mode
(button A
13 ).
– Press the M button 11 to change the colour
of the light manually. With each new press of
the M button, the colour changes into different
colours.
– If you store a desired colour during the auto-
matic colour or M mode changing sequence
by pressing the S button
12 . The stored colour
will be displayed when the device is switched
on again.
– Press the A button to switch on the automatic
colour-changing function.
– Press the button 14 to change to white light.
– Press one of the colour buttons 15 to change
into the desired colour directly.
Note: The remote control handset has a range
of 2 metres. Hold the remote control handset with
the IR diode
17 at right angles to the opening
in the top of the light.
Replacing a bulb
Press the 0 button 8 to switch off the colour-
changing lamp.
Pull the mains plug 4 out of the mains socket and
allow the lamp to cool for at least 10 minutes.
Screw the old bulb 2 out of the fitting
(see “Use”).
Screw a bulb into the lamp fitting. When doing
this check that the bulb is firmly and securely
seated.
Maintenance and cleaning
CAUTION! RISK OF ELECTRIC SHOCK!
For electrical safety reasons, never clean the
lamp
1 with water or other fluids nor immerse
it in water.
Do not use solvents such as petrol and the like,
as they could damage the lamp.
Pull the mains plug 4 out of the mains socket and
allow the lamp to cool for at least 10 minutes.
Use a dry, fluff-free cloth for cleaning.
Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Under no circumstances should the de-
vice / article and its bulbs be disposed of
with normal household rubbish.
The device / article and its bulbs should be disposed
of at an officially approved disposal centre or at your
local communal disposal facility.
Observe the applicable regulations. If you are uncer-
tain of what to do please contact your local authority’s
refuse disposal department.
Faulty or used batteries must be recycled in accord-
ance with Directive 2006 / 66 / EC. Please return
the batteries and / or the device to the available
collection points.