Livarno 2973-10L - 2973-16L - Manual (Page 8)

8 GB/IE/CY
ATTenTIOn: When you loosen the bulb 2
you also loosen the glass shade 3 .
Make sure you hold on to it.
j Only use 230 - 240 V halogen light bulbs, max-
imum 35 W and with a GU 10 base.
j Now fit the new bulb 2 and the glass shade 3
on to the spotlight together (see Fig. B). First
put the bulb
2 into the glass shade 3 . Insert
the bulb 2 carefully into the fitting and attach
it along with the glass shade 3 by turning it a
¼ turn clockwise. Now press the glass shade 3
into the spotlight 1 and lock it in place by
turning it a ¼ turn clockwise.
Check that everything is correctly seated.
Q
Maintenance and Cleaning
c CAuTIOn! DAngeR Of eLeCTRIC
SHOCk! First pull the plug 5 attached to the
mains lead out of the mains socket.
J Do not use any solvents, petrol or similar. This
would cause damage to the light.
j Allow the lamp to cool down completely.
c CAuTIOn! DAngeR Of eLeCTRIC
SHOCk! For reasons of electrical safety, the
light must never be cleaned with water or other
fluids or be immersed in water. When cleaning,
only use a dry, lint-free cloth.
Q
Disposal
The packaging and ancillary packing consist entire-
ly of environmentally-friendly materials. They can
be disposed of at your local recycling facility.
The symbol of the wheelie bin with the line
through it means that, in the European
Union, the product has to be disposed
of in a separate refuse collection. This applies to
the product and to all components bearing this
symbol. Products marked in this way may not be
disposed of along with normal domestic waste but
have to be handed in at a recycling collection point
for electrical and electronic appliances. Recycling
helps to reduce the consumption of raw materials
and to ease the burden on the environment.
Q Information
Q guarantee
You receive a 36 month warranty on this product,
valid from the date of purchase.
The device has been carefully produced under
strict quality control.
Within the warranty period we shall rectify without
charge all material and manufacturing defects. In
the event of a defect arising during the warranty
period, please send the device to the listed Service
Centre address, making reference to the following
article number: 2973-010L / 2973-016L.
Wear parts (such as bulbs) and damage caused
by improper handling, non-observance of the oper-
ating instructions or unauthorised interference are
excluded from the warranty.
The performance of services under the warranty
does not extend or renew the warranty period.
Q
Manufacturer / Service
Briloner Leuchten GmbH
Im Kissen 2, 59929 Brilon, Germany
Tel.: +49 (0) 29 61 / 97 12 - 0
Fax: +49 (0) 29 61 / 97 12 - 199
E-mail: [email protected]
Q Declaration of Conformity
This product fulfils the requirements of the applicable
European and national directives (Electromagnetic
Compatibility 2004 / 108 / EC, Low Voltage
Directive 2006 / 95 / EC). Conformity has been
demonstrated. The relevant declarations and docu-
ments are held by the manufacturer.
Operation / Maintenance and Cleaning / Disposal / Information