Livarno Energy-Saving Ceiling Lamp - Manual (Page 21)

21 GB
Preparation / Before installation / Installation / Preparing the product for use Preparing the product for use / Maintenance and cleaning / Disposal
Press the OFF button of the remote control
handset
8 to switch off the light.
Switching the light on / off using the wall
switch:
– The wall switch is in the normal position (OFF).
Switch the light off by pressing the wall switch
several times (2–3 switching cycles). The light
can then be switched off via the wall switch or
the remote control
8 .
Trouble shooting: Should the remote control 8
not react after the light has been switched on, first
press the wall switch in order to switch the light off.
Then wait for around 15–20 seconds and repeat
point 2 in the section called “Switching the light
on / off using the wall switch”. Should the remote
control
8 still not react after the light has been
switched on again, please check the batteries of
the remote control
8 .
Replacing a bulb
c CAUTION! RISK OF ELECTRIC SHOCK!
When changing the bulbs, first disconnect the light
from the mains supply. Remove its fuse or switch off
the automatic cutout in the fuse box (0 position).
CAUTION! RISK OF BURNS! Allow the light
to cool completely.
Replace the bulb 13 only after it has fully cooled.
Rotate the defective bulb 13 carefully anticlock-
wise out of the fitting 9 .
Use a clean, fluff-free cloth when you are
replacing a bulb.
Use 230–240 V ∼ energy-saving bulbs with an
E14 fitting and a maximum power output of
9 watt only.
Rotate the new bulb 13 clockwise into the fitting.
Check that the bulb is correctly seated.
Maintenance and cleaning
c CAUTION! RISK OF ELECTRIC SHOCK!
Before cleaning the lamp make sure that it is isolated
from the mains supply. Remove its fuse or switch off
the automatic cutout in the fuse box (0 position).
c CAUTION! RISK OF ELECTRIC SHOCK!
For electrical safety reasons, never clean the light
with water or other fluids or immerse it in water.
CAUTION! RISK OF BURNS! Allow the
light to cool completely.
Do not use any solvents, petrol or similar. This
would cause damage to the light.
Use a dry, fluff-free cloth for cleaning.
Disposal
The packaging and ancillary packing
consist entirely of environmentally-
friendly materials. They can be disposed
of at your local recycling facility.
The symbol of the wheelie bin with the
line through it means that, in the European
Union, the product has to be disposed
of in a separate refuse collection. This applies to
the product and to all components bearing this
symbol. Products marked in this way may not be
disposed of along with normal domestic waste but
have to be handed in at a recycling collection
point for electrical and electronic appliances.
Recycling helps to reduce the consumption of raw
materials and to ease the burden on the environment.
Batteries must not be disposed of as household
refuse! Advice is available from your local council.
Return the batteries and / or the device through the
appropriate collection facilities.