Silvercrest SZW 400 A1 - Manual (Page 11)

SZW 400 A1 9
6.3 Cleaning the carameliser
Note: The carameliser 2 must be cleaned
carefully after each use. If the carameliser 2
is dirty it will not work properly.
1. Clean the carameliser 2 by hand in
warm water.
Caution!
The carameliser 2 is not
dishwasher safe.
2. For stubborn encrustations leave it to
soak in warm water for about
20 30 minutes. You could add a few
drops of mild washing-up liquid.
Note: Water will accumulate in the
edges of the carameliser 2 during this
process. This must be removed before
the appliance can be used again.
3. Carefully shake out any water from the
carameliser 2.
4. Let the carameliser 2 dry thoroughly
before using the appliance again.
6.4 Cleaning accessories
Clean the splash guard 1, candyfloss bowl 6
and measuring spoon 11 by hand in the
sink.
The splash guard 1 and the candyfloss bowl
6
can also be cleaned in a dishwasher.
7. Faults and remedies
Water has entered the bottom section 9:
1. Remove the plug from the mains socket
immediately.
2. Turn the bottom section 9 over and leave
it to drain.
3. Have the appliance repaired by a
qualified specialist. The service address
can be found in “10. Warranty” on
page 10.
Sugar has entered the bottom section 9:
1. Remove the plug from the mains socket
immediately.
2. Allow the appliance to cool down.
3. Remove the carameliser 2.
4. Turn the bottom section 9 over and let
the sugar trickle out. Shake the
appliance gently if required.
5. If necessary, remove any sugar that has
burned onto the heating elements 5. Do
this carefully.
Caution! Never use abrasive, corrosive
or caustic cleaning materials or metal
objects to do this. These could damage
the heating elements 5.
The carameliser 2 is not turning:
Check that the carameliser 2 has been
inserted correctly (see “4. Unpacking and
setting up” on page 6).
No sugar strands are forming:
Clean the carameliser 2 thoroughly; it might
be jammed (see “6.3
Cleaning the
carameliser” on page 9).
The appliance has suddenly stopped
working:
Possibly the appliance has been in
operation for too long (see “2.1 Intended
purpose” on page 3) and the thermal cut-
out has triggered.
In this case, allow the appliance to cool
down completely, clean it (see “5.3 Thermal
cut-out” on page 8) and then use it again.
RP66929 ZuckerWG LB4 Seite 9 Freitag, 10. Juni 2011 1:17 13