Using the swap feature -21, Exit menu -21, Resetting an input – Extron electronic Digital Video Scaler Series DVS 304 AD User Manual
Page 33: Exit menu, Using the swap feature, Figure 2-19 — exit menu
2-21
DVS 304 • Installation and Operation
Using the swap feature
Use the swap feature to switch the active main window input with the current
PIP input. For example if the main window is Input 4 (RGB scaled) and the PIP
window is Input 1 (composite), applying the swap command results in Input 1
becoming the main window and Input 4 the PIP window.
For audio models (DVS 304 A or AD), you can allow audio to follow the main
(default) or PIP window. Audio breakaway is not possible while PIP mode is on;
audio must follow either the main window or the PIP window.
Exit menu
From this submenu, press the Menu button to return to the Start Auto Image menu
cycle, or press the Next button to return to the default sequence.
START AUTO
IMAGE ON IN1
MENU
MENU
INPUT
CONFIG
MEMORY
PRESETS
2 sec.
INPUT 1
COMPOSITE
OUTPUT
1024 x 768@60
Default Cycle
2 sec.
IP
CONFIG
MENU
MENU
ADVANCED
CONFIG
MENU
MENU
TO EXIT MENU
PRESS NEXT
MENU
PICTURE
CONTROL
MENU
OUTPUT
CONFIG
MENU
AUDIO
CONFIG
(Audio models only)
MENU
NEXT
Figure 2-19 — Exit menu
Resetting an Input
Each input of the DVS 304 scaler can have their parameters reset to default values
by holding down the specific input button together with menu button, until the
input number and RESET message is displayed on the LCD screen.