Setting the reminder function – Silvercrest SIUR 10 A1 User Manual
Page 136
133
SIUR 10 A1
GB
♦
Use the i /i control points
/
on the device or the i /i keys /
on the remote control to set the day for the current date.
♦
Touch the
control point
or press the i
key
on the remote
control to change to setting the month. Use the i /i control points
/
on the device or the i /i keys
/
on the remote control to set the
month for the current date.
♦
Touch the Set|OK control point
on the device or press the Set OK key
on the remote control again to save the current setting and to change to the
next menu item.
NOTE
►
The date will be reset to 01.06.2013 if the device is disconnected from the
mains power and no battery has been inserted, or if the battery is too weak.
Setting the reminder function
You can set up to 6 dates on which an automatic reminder will be triggered. The
SDA (SDA=Special Day Alert) function is useful as a reminder, for example for
a specifi c date or for birthdays or other repeating events.
Precondition: The device is in clock/standby operating mode.
♦
Touch the Set|OK control point
on the device or press the Set OK key
on the remote control three times. In the display
, the
SDA1
wording will
be shown. Touch the Set|OK control point
on the device or press the
Set OK key
on the remote control again in order to select the required
memory slots
SDA2
to
SDA6
.
♦
Then touch the
control point
or press the i
key on the
remote control, in order to enter the required date and required alarm time
using the i /i control points
/
or
control point
(or the i /
i keys
/
or i
keys
on the remote control). If you select a
specifi c year, you will then be programming a single-instance alarm. If you
select
ALL
instead of a year, the device will remind you of the date every year.
♦
After this, press the i control point
on the device or press the i key
on the remote control, in order to switch the blinking
OFF
over to
ON
and
therefore to activate the alarm.
♦
Proceed as above to program the remaining memory slots.
♦
Touch the Set|OK control point
on the device or press the Set OK key
on the remote control again to save the current setting and to change to the
next menu item.
IB_86209_SIUR10A1_LB1.indb 133
IB_86209_SIUR10A1_LB1.indb 133
11.03.13 09:21
11.03.13 09:21