Epson Dreamio EMP-TW1000 U - Manual (Page 10)

8
Part Names and Functions
Rear
Base
•
[SCART] input port p.12
Connects to the component
(YCbCr or YPbPr) out port or D
out port of the video equipment.
•
[Trigger out] port
When the projector power
is turned on, a 12 V DC
signal is output from this port.
When the projector's power is
turned off or a problem with
operation occurs, the output
becomes 0 V to send the
projector's power ON/OFF
status to an external device.
•
[Video] input port p.12
Connects to general video out
ports of the video equipment.
•
[HDMI ] input port p.12
Connects to video equipment or a
computer that is HDMI-
compatible.
•
[S-Video] input port p.12
Connects to the S-Video out ports of
the video equipment.
•
[RS-232C] port
Connects the projector to a computer
using an RS-232C cable. This port is
for control use and should not be used
by the customer.
•
Power inlet p.14
Connects the power cable.
•
Main power switch
p.14
•
Security lock
p.55
•
Remote control
light-receiving
area
p.13
Receives signals
from the remote
control.
•
[PC] input port p.12
Connects to the RGB out
port of the computer.
•
[Component] input port p.12
Connects to the component (YCbCr or YPbPr ) out port of the
video equipment.
•
Suspension bracket fixing points (4 points) p.48
Install the optional ceiling mount here when suspending the projector from a ceiling.
•
Air filter (air intake vent)
p.44, 46
Prevents dust and other foreign particles
from being drawn into the projector.
It should be cleaned periodically.
•
Lamp cover p.46
Open this cover when replacing the lamp
inside.