Car safety jacket • introduction, Usage restrictions, Storage instructions – Powerfix HIGH VISIBILITY VEST User Manual

Page 13: Performance level, Ce mark

Advertising
background image

Car safety jacket

• Introduction

Congratulations on your purchase. You have chosen a

high quality product. The instructions for use are part of this

product. Please familiarise yourself with all instructions for

use and safety instructions before using the device. Only

use the product as described and for the stated areas of

use. Hand over all documents when passing on the product

to a third party.

• Information note

Safety jacket

Category II, class: 2.2 Certification EN 471:2003 +

A1:2007

TÜV Rheinland LGA Products GmbH (0197), Tillystraße 2D

- 90431 Nuremberg

• Use

The garments correspond to the safety characteristics

of the European Norm E471:2003+A1:2007 with

regards to the high visibility requirements. Safety is

only guaranteed, if the garment is a suitable size

and is buttoned up properly. Before use you should

make sure that the garment is clean and that there

are no rips, unstitched seams or other defects, that

could restrict its properties. NOTE: The visibility

properties of the garments are to be seen as

restricted if these items are not completely clean

or have been subjected to unauthorised changes.

• Usage restrictions

The garment is for use in the case of a limited range

of vision. It is NOT to be used as protection against

chemical risks, heat and fire, cold, electricity or any

other risks.

• Storage instructions

The garments must be stored in their original

packaging, in a cool, dry place without dust, away

from heat sources and direct light.

• Performance level

X = luminous and reflective materi-

al class (minimal areas with visible

material in m

2

)

1 = luminous 0.14 m

2

reflective 0.10 m

2

2 = luminous 0.50 m

2

reflective 0.13 m

2

3 = luminous 0.80 m

2

reflective 0.20 m

2

Y = luminous depth coefficient of

the reflective material.

1= schema VI EN

471:2003+A1:2007

2= schema VI EN

471:2003+A1:2007

• CE mark

The CE mark on a product means that the product

corresponds to the requirements of the European

guideline 89/686/EEC and has been checked by

an accredited institute.

GB 13

X

Y

Advertising