Powerfix Z31697A - Manual (Page 54)

54 GB/MT
used battery more easily with the aid of the
material strip, which is inside the battery
compartment. Just pull on the material strip.
Remove the used battery.
Plug the contacts of the 9 V block battery on
the contacts of the profiled plug. Make sure
you fit the batteries the right way round. This
is specified by the profiled shape of the con-
tacts. Also ensure without fail that the material
strip is underneath the battery.
Insert the battery in the battery compartment
and close the cover again, so that it audibly
latches into place.
Start-up
Measuring length
Press the ON/OFF button 9 to switch the
device on. If you do not press any button for
60 s, the display
10 shuts down.
To switch the device off manually, hold the
ON/OFF button pressed down for 3 sec-
onds, until the display goes out and a double
tone signal sounds.
Press the MODE button 8 repeatedly, until
the display shows the symbol for length meas-
urement „ “ as well as the length designa-
tion 0.00m (or 0‘00“).
Hold the reference area 6 of the ultrasonic
rangefinder at the start point of your meas-
urement. Hold the device in such a way, that
the reference area is aligned parallel to the
target area of the measurement.
If necessary use the level indicator 7 to
align the ultrasonic rangefinder horizontally.