Powerfix Z31697A - Manual (Page 57)

57 GB/MT
Measuring surface area
Note: In order to avoid errors in the measuring
method, please familiarize yourself first with the
information about measuring lengths.
Press the ON/OFF button 9 to switch the
device on.
Press the MODE button 8 repeatedly until
the symbol for surface area measurement
„
“, as well as the designation 0.00 m
(or 0‘00“), appear in the display 10 . The
symbol „ “ for length measurement flashes.
The device displays in this way, that it is
ready for the first measurement.
Align the device and press the READ button
4 . If the measurement is successful, the
length will appear at the top of the display.
The symbol for width measurement „
“
also flashes. The device displays in this way,
that it is ready for the measurement of the width.
Align the device and press the READ button
again. If the measurement is successful, the
width appears at the top of the display, and
at the bottom appears the surface area in the
m
2 unit of measurement (or sq.ft = square feet).
Press the MODE button briefly, if a further
surface area measurement is required. The
figures in the display are reset, and the device
is ready for a new surface area measurement.
Measuring volume
Note: In order to avoid errors in the measuring
method, please familiarize yourself first with the
information about measuring lengths.