Equator WB 818 - Manual (Page 11)

start or run. ● Motor (bad bearings or locked
rotor).
◇Replace motor.
Motor trips out on in
terminal thermal overload
protector.
●Start relay not dropping out.
●Improper voltage.
●Seal faces binding.
●Motor shaft binding.
●Motor windings shorted.
●Glass or foreign items in pump.
◇Replace start relay.
◇Check voltage.
◇Repair or replace.
◇Repair or replace.
◇Repair motor.
◇Clean and clear area.
Repeated dishwasher cycles ● Circuit board (contacts open or
burnt)
● Motor (inoperative, check
resistances).
◇Replace circuit board.
◇Replace timer.
Dishwasher does not
advance automatically.
● Damaged circuit board.
●Check circuit for power ,check if
the wire misconnected.
●Have wire cut off
◇Replace circuit board.
◇ Reconnected wire and circuit
board .
◇Repair.
Dishwasher will not fill with
water.
●Water supply turns off.
●Defective inlet valve.
● Check valve screen for
obstructions.
●Defective float switch.
●Damaged circuit board.
●Wiring (broken or burnt).
◇Turn water supply on.
◇Replace inlet valve.
◇Disassemble and clean screen.
◇Replace switch.
◇Replace circuit board .
◇Repair or replace.
Incomplete water fill. ●Low water pressure.
●Clogged water inlet valve screen.
● Heavy water supply usage
elsewhere in home.
●Kinked or restricted fill hose, water
inlet valve to fill tunnel.
◇ Minimum water pressure of
15P.S.I
◇Clean water inlet valve screen.
◇ Use dishwasher when water
usage is at a minimum.
◇Correct as needed.
Too much water fill. ●Water inlet fill valve defective.
● Damaged circuit board (open or
burnt).
● Float arm binding or out of
adjustment.
◇Replace water inlet fill valve.
◇Replace circuit board.
◇Repair, adjust or replace.
Dishwasher will not pump
out.
●Drain pump is restricted.
●Damaged impeller.
●Wiring or terminal (contacts open
or burnt).
◇Clear restrictions.
◇Replace drain pump.
◇Replace circuit board.
Water siphons out. ●Drain hose loop to low.
● Drain line connected to a floor
drain not vented.
◇Move to proper height.
◇Install vent air gap at counter
top.
Water leaks. ●Spray arm not rotating or split. ◇ Check for proper rotation or
replace spray arm.
11