Hotpoint Ariston KM 040 AX0 - Manual (Page 11)

11
it en
examination, repair, or electrical
or mechanical adjustment.
• Do not leave the appliance unat-
tended while it is running.
• Connect and operate the appliance only in ac-
cordance with the specifications on the rating
plate.
• Read all instructions. Keep these instructions for
future use.
• To protect against risk of electrical shock, do not
immerse base, cord, or plug in water or other
liquid.
• If the power is interrupted, the appliance remains
switched on and restarts when the power is re-
stored.
• Avoid contacting moving parts and keep fingers
out of discharge opening.
• To prevent injury, repairs such as replacing a
damaged cord should only be carried out by our
customer service.
• The use of attachments not recommended or
sold by the appliance manufacturer may cause
fire, electric shock, or injury.
• Remove the bowl and any utensils from the
appliance before washing them.
• Do not use outdoors.
• Do not let cord hang over edge of table or coun-
ter or touch hot surfaces.
• Do not operate this appliance in the presence of
explosive and/or flammable fumes.
• This appliance is intended for household use
only, not for commercial or industrial use. Use
for anything other than the intended purpose will
void the warranty.
• To reduce the risk of electric shock, do not at-
tempt to remove the bottom cover. There are no
user serviceable parts inside. Repair should be
done only by authorized personnel.
BEFORE FIRST USE
Before the first use, wash the flat beater, dough hook
and steel bowl using warm water and detergent.
Rinse and dry thoroughly.
Handwash the wire whisk.
• Clean the outside of the machine with a soft
damp cloth, then wipe it dry.
• Place the machine on a dry steady flat surface
such as a counter or table. Keep it away from the
edge of the work surface.
Do not use abrasive detergents or wire wool
to clean the machine.
Do not immerse the body of the machine in
water or any other liquid.
USING THE APPLIANCE
Locking and releasing the motor head
(A)
To insert and remove any utensils and bowls, you will
need to lift the motor head first. Perform the following
operations:
1. Rotate the releasing lever anticlockwise
2. Use your other hand to gently lift the motor head
until it stops
3. Let go of the releasing lever and rotate it
clockwise towards its starting position.
Having inserted the utensils, lower the motor head
again. Perform the following operations:
1. Rotate the releasing lever anticlockwise
2. Use your other hand to gently rotate the motor
head downwards until it stops
3. Let go of the releasing lever and rotate it
clockwise towards its starting position.
Never let go of either the motor head or lever
until the operation is complete - both in the
lifting and lowering steps.
In the motor-head locking and releasing
steps, make sure your fingers do not get
close to the articulated joint to avoid injuries.
Never switch on the appliance with inserted
utensils unless the bowl is properly in place.
Fitting and removing the bowl (B)
Fit the bowl through the following operations:
1. Make sure the appliance is off.
2. Unplug it.
3. Release and lift the motor head.
4. Place the bowl on the locking plate.
5. Slightly rotate the bowl clockwise until it locks in
place completely.
To remove it:
1. Make sure the appliance is off.
2. Unplug it.
3. Release and lift the motor head.