MCZ Cap NATURAL - Manual (Page 66)

64
15-CLEANING
ATTENTION!
All the cleaning operations of all parts must be performed with the product completely cold and the plug
disconnected.
Disconnect the product from the 230V power supply before performing any maintenance operation.
The product requires little maintenance if used with certified good quality pellets.
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
Before each lighting
Clean and empty any ash or deposits from ash drawer “C” that might obstruct the air flow holes, paying attention to any hot ashes.
If the pellets in the hopper run out, unburned pellets may accumulate in the brazier. Always empty the residue in the brazier before each
start-up.
You may only use a vacuum cleaner to remove ash when it is completely cold. In this case, use a suitable vacuum cleaner
to remove small sized particles. The quality of the pellets used and user experience will determine the cleaning frequency required.
However, it is recommended not to exceed 2 or 3 days.
REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE IGNITION AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT.
For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the
bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the
component.
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specific detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass cleaning product on the painted parts and on the door
gaskets (ceramic fibre cord).
EXAMPLE OF A CLEAN BRAZIER EXAMPLE OF A DIRTY BRAZIER