MCZ Club AIR - Manual (Page 35)

PELLET STOVES Chapter 3
INSTALLATION AND USE MANUAL page 35
Installation and assembly Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
3.5. INSTALLATION OF AIR FILTER
Before placing the stove near the wall for connection to the flue
pipe and to the electrical mains, install the air filter provided
with the stove.
The cylindrical filter is composed of a metallic net and is included with
the accessories (along with the glove, hook, instructions, and so on).
The filter must be inserted on the air inlet pipe Ø 5 cm.
To remove it, slightly loosen the screw with the knob on the air inlet,
insert the filter matching it with the filter groove with the screw of the
knob and then secure it by tightening the knob.
ATTENTION!
Never operate the stove without the air filter. MCZ
shall not be held liable for damage to internal
components if this instruction is not followed.
3.6. OPENING/CLOSING OF ATHOS STOVE DOOR
ATTENTION!
In order for the stove to operate correctly, it is
essential that the door be closed completely.
In Suite/Club/Musa stoves the door is opened using the hook on the
door which must be lifted by the cool hand supplied (fig.11); whereas
for the Sagar/Toba/Nima stoves slide the cool hand onto door hook, lift
and pull (fig.12).
3.7. MAKING THE ELECTRICAL CONNECTIONS
Connect the supply cable first at the rear of the stove and then to an
electrical outlet on the wall.
The main switch located on the rear of the stove should be switched on
only when you want to light the stove.
When the stove is not being used, it is advisable to
keep it unplugged.
Installation/removal of air filter
Fig. 11 - Opening/closing the door
Suite/Club/Musa
Fig.12 - Opening/closing the door
Sagar/Toba/Nima
Electrical connection of the stove