MCZ Ego AIR - Manual (Page 18)

PELLET STOVES Chapter 3
INSTALLATION AND USE MANUAL page 18
Installation and fitting Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
3.2.
PREPARATION AND UNPACK ING
STAR AND EGO stoves are delivered with two different packagings:
 The EGO stove has one packaging
o It contains the stove and the steel sides with the
profiles (Fig.1)
 The STAR stove has two packagings
o One contains the stove and the profile for the ceramic
or the soapstone
o One contains the ceramic (fig.2). In this case there will
be a single packaging for the structure (the cardboard
with the ceramics will be placed above the packaging
with the structure)
o or Soapstone (fig.3) (in this case there are two
packagings structure + soapstone pallet)
Open the packaging, remove the four screws that secure the base of
the stove to the pallet, two to the right and two to the left (see figure
4), and position the stove in the selected place, ensuring that it is
complies with the above instructions.
The stove body or unit must always be kept in a vertical position when
moved, and moved only using carts. Special care must be used to
protect the door and the glass from impacts that would damage them.
Moving the product must always be done with care. If possible, unpack
the stove in the area where it is going to be installed.
The materials which make up the packaging are not toxic or harmful, so
no special procedures for disposal by required.
Their storage, disposal or possible recycling are therefore the responsibility of
the final user, in compliance with current legislation on the subject.
Do not store the stove unit or its cladding without their packaging.
Figure 1 – Example of packaging stove
+ steel sides (Ego stove)
Figure 2 - Example of packing for
ceramics
Figure 3 - Example of soapstone
packaging
Figure 4 - Removing packaging screws (in
figure Ego stove)