MCZ Ego AIR User Manual

Page 58

Advertising
background image

PELLET STOVES

Chapter 6

INSTALLATION AND USE MANUAL

page

58

Problems/Causes/Solutions

Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited

PROBLEM

POSSIBLE CAUSES

REMEDY

The smoke extraction

motor does not work.

No electrical supply to the stove.

The motor is broken.

Defective electronic board.

Control panel broken.

Check the supply voltage and the

protection fuse.

Check the motor and capacitor and

replace if necessary.

Replace electronic board.

Replace the control panel.

The convection air fan

runs continuously.

Temperature sensor defective or broken.

Fan broken.

Check the operation of the sensor

and replace if necessary.

Check the operation of the motor

and replace if necessary.

Remote control does

not work (if purchased

/ optional)

Remote control batteries flat.

Remote control broken.

Replace batteries.

Replace remote control.

In

the

automatic

position

the

stove

always runs at full

power.

Room thermostat set to maximum.

Temperature sensor defective.

Control panel defective or broken.

Reset the thermostat temperature.

Check the operation of the sensor

and replace if necessary.

Check the panel and replace if

necessary.

The stove does not run

Lack of electricity supply.

Pellet sensor in lockout.

Fuse blown.

Check that the electric socket is plugged

in and that the main switch is in position

“I”.

Clear lockout by resetting the rear

thermostat, replace the thermostat if

it happens again.

Replace the fuse.

The stove does not

light

Make sure that the grate is clean

Check the position of the grate

Make sure that the sparkplug heats

Smoke outlet or duct blocked

Clean the grate of any incrustations or

residues of unburnt pellets.

Put the grate back in its seat.

Check and replace if necessary.

Clean the smoke outlet and/or smoke

duct

ATTENTION
The operations marked in bold type must be carried

out by specialised MCZ personnel.
The manufacturer refuses to accept any responsibility

and the guarantee lapses if this condition is not

respected.

Advertising
This manual is related to the following products: