MCZ PowerTherm - Manual (Page 50)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 50
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
D
G
4.15. SYNCHRONIZATION OF REMOTE CONTROL
Upon first start-up of the product, it may be necessary to get the stove
to recognize the new remote control. To carry-out this operation, follow
the simple instructions that follow:
x connect the stove to the socket and switch the power supply
button on
x ensure that the selector D of the emergency panel is in the
position REMOTE
x when the first text appears onto the display of the emergency
panel, press the embedded button G with the aid of a pointy
object (toothpick..)
x three flashing lines “---“ will appear on the display. Press the
on/off button of the remote control for confirmation.
The three flashing lines will disappear from the display and the stove
will recognise the new communication address of the remote control.
Recognition will also be confirmed by 4 acoustic sounds.
4.16. SAFETY DEVICES
The stove is fitted with the following safety devices:
x SMOKE TEMPERATURE SENSOR.
Monitors the temperature of the smoke, and gives permission for
start-up or shuts the stove down when the smoke temperature
falls below the preset value.
x PELLET HOPPER TEMPERATURE SENSOR.
If the temperature exceeds the preset safety level, it immediately
shuts down the running of the stove, and has to be reset
manually, after the stove has cooled, before the it will restart.
x ELECTRICAL SAFETY
The stove is protected against violent surges of current by the
main fuse, which is located on the control panel at the rear of the
stove. Other fuses to protect the electronic boards are to be found
on the boards themselves.
x FAILURE OF THE SMOKE EXTRACTION FAN
If the fan stops, the electronic board shuts off the supply of pellets
in good time, and an alarm is displayed.
x BREAKDOWN OF THE REDUCTION MOTOR
If the reduction motor stops, the stove continues to function until
it has cooled down to the minimum level.
x TEMPORARY POWER CUT
If there is a power outage during operation, when the power
comes back on the stove will go into cooling mode and then it will
come back on automatically.
x FAILURE TO LIGHT
If during ignition no flame develops, the stove will go into alarm
condition.