Medal Sports WMUSA1395300 - Manual (Page 3)

www.themdsports.com 1395300
2
(Continued on the next page.)
Unpacking the Game
Unpack your new dartboard carefully, making sure all parts are included. The following components are included in
this set:
• 1 Electronic Dartboard
• 6 Darts (unassembled)
• Owner’s Manual
This dartboard may have a protective film over the scoring display. Film should be
removed for better clarity
Batteries
This dartboard requires 3 AAA (1.5 volt) Batteries to operate . BATTERIES NOT INCLUDED. Do NOT
mix old and new batteries and do not mix alkaline, standard (carb on zinc), or
rechargeable (nickel cadmium) batteries.
Do not dispose of batteries in fire, batteries may explode or leak.
Cricket Scoring Display
This dartboard utilizes a dedicated cricket scoreboard within the scoring display that keeps track of each player’s
segment status when playing Cricket. When Cricket is selected, individual characters will be utilized to register
marks. There are 3 separate lights within each number (15 through 20 and bulls eye). During play, one of the status
lights will turn on (black will appear) as a segment is hit. If a double or triple of an active number is hit, 2 or 3 lights
will turn on respectively.
Setup / Mounting Instructions
Choose a location to hang the dartboard where there is about 10 feet of open space in front of the board. The
“toe-line” should be 7 feet 9 1/4 inches from the face of the dartboard.
Locate a wall stud and place a mark 75.5 inches from the floor. This mark is for the top screw hole. For the bottom
two screws, you will measure down 12.4 inches from the top mark you just made and make a temporary reference
mark. (do not drill a hole for the temporary reference mark)
You will need to place a mark 5.3 inches to the left of that reference mark point for the bottom left screw hole and
then make another mark 5.3 inches to the right of the original reference mark for your bottom right screw hole.
Insert mounting screws in the center of the marks you made. (do not drill into the TEMPORARY REFERENCE
MARK) Mount the dartboard on the wall by lining up the holes on the back with the screws. It may be necessary to
adjust the screws until the board fits snugly against the wall.
Center of Bullseye should be 5 ft 8 inches from the floor when finshed
X
X
Wall Stud
Bottom
Screw
63.1 in
Top Screw
75.5 in
Floor 7 ft 9 ¼ in
Toe Line
5 ft 8 in from Floor
to Center of
Bullseye
Dartboard