Enterasys Networks D-Series - Manual (Page 469)

clear radius
Enterasys D-Series CLI Reference 17-7
This example shows how to force any management‐access to the switch (Telnet, web, SSH) to
authenticate through a RADIUS server. The all parameter at the end of the command means that
any of the defined RADIUS servers can be used for this Authentication.
D2(rw)->set radius realm management-access all
clear radius
Use this command to clear RADIUS server settings.
Syntax
clear radius [retries] | [timeout] | [server {index | all | realm {index | all}}]
Parameters
Mode
Switch command, read‐write.
Defaults
None.
Examples
This example shows how to clear all settings on all RADIUS servers:
D2(su)->clear radius server all
This example shows how to reset the RADIUS timeout to the default value of 20 seconds:
D2(su)->clear radius timeout
show radius accounting
Use this command to display the RADIUS accounting configuration. This transmits accounting
information between a network access server and a shared accounting server.
Syntax
show radius accounting [server] | [counter ip-address] | [retries] | [timeout]
retries Resets the maximum number of attempts a user can contact the RADIUS
server before timing out to 3.
timeout Resets the maximum amount of time to establish contact with the RADIUS
server before timing out to 20 seconds.
server Deletes server settings.
index | all For use with the server parameter to clear the server configuration for all
servers or a specific RADIUS server as defined by an index.
realm Resets the realm setting for all servers or a specific RADIUS server as
defined by an index.