Qlima A45 User Manual
Page 60
60
4
1
2
3
Picture 10
1. Removable pre-filter
2. HEPA filter
3. Active Carbon Filter
When the air cleaner is switched on the ioniser is also automatically switched on.
This ensures that the air cleaner will always function optimally.
G
REPLACING THE FILTER PACKAGE
The frequency with which the air cleaner is used and the circumstances determine how of-
ten the filter must be replaced. The air cleaner is equipped with a warning signal, Light 4,
which will flash if the filter needs to be replaced.
1.
Unplug the device from the wall socket.
2.
Remove the back panel. (See chapter Installation)
3.
Remove the filter package. (4x)
4.
Remove the packing material from the new filter package (4x) and place it in the air
cleaner. See the chapter on Installation for the correct way to insert the filter pack-
age.
5.
Replace the panel.
6.
Plug the air cleaner into the wall socket again and turn it on.
7.
Reset the filter alarm by pressing Button 1 and holding it depressed for 3 seconds
until Light 4 stops flashing.
8.
The air cleaner is now ready for use again.
9.
Used filters can be disposed of in the regular house hold garbage without a problem.
G
If light 4 is flashing then the filter package must be replaced. The filter alarm can
be reset by pressing for 3 seconds button 1 on the control panel or button 4 on
remote control.
G
ATTENTION!
• Always replace dirty filters with new filters. Never re-use a dirty filter, even after
it has been cleaned.
• Depending on the circumstances it might be comfortable to replace the filters
more frequent.
60