Qlima A45 - Manual (Page 62)

62
4
TROUBLESHOOTING
Check the following before contacting technical support:
Problem Cause Solution
Light 4 on the display is
blinking
Dirty filters
Replace the filter package (4x)
and reset the filter alarm by pres-
sing for 3 seconds button 1 on
the control panel or button 4 on
the remote control.
The device does not
work
The back panel has not been
replaced correctly.
Remove the panel and put it
back again. Make sure that the
top of the panel is placed cor-
rectly.
The power cord is not connected. Insert the plug into the socket.
The power cord is not connected
properly. Insert the plug into the socket
correctly.
The fuse of the unit is defective.
Have the fuse replaced by a
recognised Qlima dealer.
The remote control is
not working. The batteries in the remote con-
trol are dead.
Replace the batteries.
The device does not
remove odours and/or
dust.
The filter package has not been
inserted correctly. Insert the filter package cor-
rectly.
The filter package is dirty. Replace the filter package.
The Auto mode doesn't
work.
The sensor is dirty.
Use cotton swabs to clear the
sensor.
No / insufficient air circu-
lation.
The air flow is blocked.
Remove the blockage.
Replace the filters. (4x)
62