Eureka 2500 - Manual (Page 12)

V. OPERATING THE CARPET SHAMPOOER/EXTRACTOR
D. Push power switch on, which is located on the back side of the
unit.
E. Pull up and hold the solution release trigger and apply two
spraying strokes by moving the carpet shampooer/extractor
forward and then backward at a moderate pace two times. As
the nozzle moves over the carpet, the cleaning solution is
sprayed onto the carpet. At the same time the nozzle picks up
the dirty water and places it in the recovery tank. It is important
to move the carpet shampooer/extractor in a steady motion
over any surface.
F. Release the trigger to stop the solution flow. Avoid over-
soaking.
G. Move the carpet shampooer/extractor over the carpet several
more times without engaging the trigger. This removes excess
water and helps the carpet dry faster.
H. Repeat steps E, F, and G on heavily soiled areas.
Transporting the Carpet Shampooer/Extractor
When moving the carpet shampooer/extractor from one location to another, always make sure the recovery and clean water
solution tanks are completely empty. Then tilt the unit slightly backward and roll on rear wheels or use the carpet shampooer/
extractor’s carrying handle for transporting up and down stairs.
12
( )
Power
Switch
0 = Off
I = On
Some Eureka carpet shampooer/extractor
models do not feature an attachment hose and
selector knob. These features are specified only
on selected models.