RISCO Group LightSYS - Manual (Page 4)

4 LightSYS Quick User Guide
Telephone Control Commands
Remark: Available only if your LightSYS is equipped with the voice module.
Receiving a call:
1. Pick up the phone.
2. Say “Hello” press [#]. You will
hear an event announcement
message.
3. Choose an option from the
Acknowledgment menu.
Acknowledgment menu
Acknowledge message: [1]
Acknowledge and stop all dialing: [2] [User
code] [#]
Access Operations menu: [3] [User code] [#]
Listen and Talk: [6] [3] [User code]
Repeat the event message: [#]
Repeat the Acknowledgment menu: [*]
Calling the System :
1. Dial the number of the premises.
•
If an answering machine is
present at the premises: Let
the line ring once, hang up
and call again.
•
If an answering machine is
not in use at the premises:
Wait until the system picks
up. You will hear a
continuous tone .
2. After the tones, enter the 2-digit
remote access code.
3. Enter your user code followed by
[#].
4. Choose your option from the
Operations menu.
Operations Menu :
Arming all Partitions: [1] [1]
Arming by Partition: [1] [9] [Partition no.]
Disarming all Partitions: [2] [2]
Disarming by Partition: [2] [9] [Partition no.]
Changing Zone Bypass: [3] [Zone no.] [#] [9]
Operating Utility Outputs: [4] [UO no.]
Changing FM Numbers: [5] [FM no.] [#] [2]
[New phone no.]: [#] [1]
Listen in: [6] [1]
Talk: [6] [2]
Listen and Talk : [6] [3]
Record Messages : [7]
Exiting the System: [0]
Repeat the Menu: [#]
Return to previous menu: [*]
© RISCO Group 05/2011
5IN1520 B