Riello UPS PowerShield³ - Manual (Page 64)

64 • Uninstallation of the UPSMON UPSMON User Manual
1.3 Display for the sensors associated with an SNMP adapter
A maximum of six temperature, humidity or input/output sensors may be connected to the SNMP adapter through the serial port (refer
to the sensor cable wiring specifications). If these sensors are connected, the Upsview module can be used to check that they are
operational and view the measurements being recorded.
The types of sensors available are:
•
Temperature: measures the environmental temperature in °C.
•
Humidity and temperature: measures the relative humidity in % and the environmental temperature in °C.
•
In/Out and temperature: measures the environmental temperature in °C and provides one digital input and one digital output.
The figure below shows the screen shot illustrating the sensors associated with the SNMP adapter. Following a refresh operation, all the
adapters to which sensors have been connected, will be included within the tree structure with an extra indent level and the caption
“Netman Sensors”. Select the caption to view the measurements recorded by the sensors and their effective operating status. The figure
also features an In/Out sensor, a temperature sensor and a humidity sensor. If more than three sensors are connected to the adapter, the
next three can be viewed by clicking on the button at the bottom right of the screen.
Please refer to the SNMP adapter manual for further information on the sensors that can be associated with the adapter.
ATTENTION.: this function is active only for remotely connected SNMP adapters. In order to see the sensors, they must be
configured (up to a maximum of 32 sensors) in the Upsetup module, or a Refresh operation executed. The threshold settings
are active on the sensors configured in the Upsetup module.