RIGOL DS6000 Series User Manual
Page 54
RIGOL
18
User’s Guide for RP7000 Series Active Probe
① Solder-in differential probe head (RP7-0201).
② 0.2mm Nickel Wire (RP7-0306).
When the points to be tested are widely spaced, the length of the nickel wire
will be increased. At this point, overshoot and ringing will occurs and the
high-frequency response will changes.
4. Solder-in Single-ended Probe Head
The solder-in single-ended probe head provides an effective bandwidth of more
than 1.5GHz and its replaceable nickel wire enhance the usability of the probe
and prolong its service life.
The structure of the solder-in single-ended probe head is as shown in Figure
12.
The pin on the same side with the negative pole mark sleeve (refer to Figure 8)
is negative.
Figure 12 Solder-in Single-ended Probe Head
①
②