RIGOL M300 - Manual (Page 43)

Chapter 2 Command System RIGOL
Programming Guide for DM3000 2-31
:UTILity Commands
The commands are used to control and test the communication of the instrument.
Before controlling the communication, make sure that the related communication
interface has been connected stably; otherwise, abnormalities or errors might occur.
The commands mainly include:
 :UTILity:INTErface:LAN:DHCP*
 :UTILity:INTErface:LAN:AUTOip*
 :UTILity:INTErface:LAN:MANUip*
 :UTILity:INTErface:LAN:IP*
 :UTILity:INTErface:LAN:MASK*
 :UTILity:INTErface:LAN:GATEway*
 :UTILity:INTErface:LAN:DNS*
 :UTILity:INTErface:GPIB:ADDRess*
 :UTILity:INTErface:RS232:BAUD
 :UTILity:INTErface:RS232:PARIty
 :UTILity:INTErface:USB:ID?
Note: commands marked with * are only applicable to DM3064, DM3062, DM3054
and DM3052.