Rose Electronics Xtensys - Manual (Page 12)

6 Installation and Operations Manual
Keyboard switching commands – XTR-11
Switching to a computer that is connected to an Xtensys switch using simple
keyboard commands is performed by pressing and releasing the left Ctrl key
and, within 2 seconds, enter the computer port to switch to and then press
Enter.
Example: To switch to computer port #19 on the connected Xtensys switch,
press and release the left Ctrl key, type in 19, and press enter.
Switching to a computer – XTR-12 / XTR-14 model
To display the OSD list of computers using the KVM station connected to
the XTR-14 model, press and release the left Ctrl key then the Esc key. The
window shown in figure 3 will display.
Note: The computer select window is different for the XTR-11 model.
Figure 3. XTR-14 Computer select window
The left column has two rows of numbers (01-01). The left number is the
computer port number on the Xtensys switch. The right number is the RJ45
port on the user station (the right port is #1, left port is #2 or #4)
Scrolling down will display the additional computers.