Switching between ntsc and pal – Epson ELPDC02 User Manual
Page 37
Solving Problems
31
■
The presentation material may be too far from the lens. Flip down
the close-up lens.
■
Make sure there is no condensation on the lenses. You may need
to wait before using the document camera after moving it from a
cold environment to a warm environment.
Switching Between NTSC and PAL
For video output, the document camera is set at the factory to NTSC
mode. Follow the steps below to switch to PAL mode.
Before you start, make sure your document camera is plugged in.
1. Make sure the document camera is turned off.
2. Press and hold the
Main
button on the document camera’s
control panel.
3. Turn on the document camera.
4. Release the
Main
button.
The document camera will remain in PAL mode, even after turning it
off. To switch back to NTSC mode, repeat the same steps.
Control panel
Main