KEPCO MST 488 Programmer - Manual (Page 25)

MST 488-27 013004
2-7/(2-8 Blank)
TABLE 2-4. INPUT/OUTPUT PIN ASSIGNMENTS
CONNECTOR PIN SIGNAL NAME FUNCTION
RS232-C
PORT
1 SGND Signal Ground
2 RXD Receive Data
3 TXD Transmit Data
4 DTR (not used)
5 SGND Signal Ground
6 DSR See Note 2.
7 RTS See Notes 1 and 2.
8 CTS See Note 1.
9 SGND Signal Ground
NOTE 1 Jumper installed between CTS and RTS allows DIP switches to configure RS 232
port. Jumper NOT installed established default RS 232 configuration (9600 baud,
Echo on, XON off).
NOTE 2 Jumper installed beteen DSR and RTS allows secondary GPIB addressing if SCPII
mode 0 (see Table 2-2) is selected
IEEE 488
PORT
1 D I 01 I/O Line
2 D I 02 I/O Line
3 D I 03 I/O Line
4 D I 04 I/O Line
5 EOI End or Identify
6 DAV Data Valid
7 NRFD Not Ready for Data
8 NDAC Not Data Accepted
9 IFC Interface Clear
10 SRQ Service Request
11 ATN Attention
12 SHIELD Shield
13 D I 05 I/O Line
14 D I 06 I/O Line
15 D I 07 I/O Line
16 D I 08 I/O Line
17 REN Remote Enable
18 GND Ground (signal common)
19 GND Ground (signal common)
20 GND Ground (signal common)
21 GND Ground (signal common)
22 GND Ground (signal common)
23 GND Ground (signal common)
24 LOGIC GND Logic Ground