Amprobe ACD-14-PLUS Clamp-On-Multimeters - Manual (Page 13)

10
Refer to the LIMITED WARRANTY section for obtaining warranty or service.
Cleaning and Storage
Periodically wipe the case with a damp cloth and mild detergent; do not use abrasives
or solvents. If the meter is not to be used for periods of longer than 60 days, remove the
battery and store separately.
Battery replacement
The meter uses two 3V IEC-CR2032 coin batteries. Remove the test leads and loosen the
two screws from the case bottom and remove the bottom case. Slide the battery out the
side of the holder and replace with a new battery (observe polarity). Replace the bottom
case. Re-fasten the screws.
GENERAL SPECIFICATIONS
Display: 3-3/4 digits 4000 counts LCD display
Update Rate: 3 per second nominal
Polarity: Automatic
Operating Temperature: 0 °C to 40 °C; < 80% RH for temperature up to 31 °C decreasing
linearly to 50% RH at 40 °C
Altitude: Operating below 2000m; Indoor use
Storage Temperature: -20 °C to 60 °C, < 80% RH (with battery removed)
Temperature Coefficient: nominal 0.15 x (specified accuracy)/°C @ (0 °C ~ 18 °C
or 28 °C ~ 40 °C)
Low Battery: Below approx. 2.4V
Power Supply: 2 each 3V coin battery IEC-CR2032
Power Consumption: 2.8 mA typical except that 3.3 mA typical for ACA function
APO Timing: Idle for 30 minutes
APO Consumption: 5μA typical on all functions except that 40μA typical on voltage
function
Dimension: 190 x 63 x 32 mm (7.4 x 2.5 x 1.3 in)
Weight: 207 gm (.5 lb.)
Jaw Opening & Conductor Diameter: max 26 mm (1”)
Accessories: Test leads (pair), batteries, user’s manual, soft carrying case, and banana plug
type-K bead probe
Special Features: 30ms Max Hold; Data Hold; Simultaneous A+V, A+Hz