Amprobe TMD-51 Thermocouple-Thermometer - Manual (Page 12)

5
holding down the “MAX/MIN” key for 2 seconds to exit
and erased recorded reading.
“CLR/READ” Button
Press “READ” key to enter READ Mode, the “READ”
annunciator is displayed at upper-right corner. Press “p”
or “q” key to review the data you recorded. The LCD
automatically scrolls data and index.
Pressing “CLR” key and holding down for 2 seconds to
clear the memory data.
“REC” Button
There are 125 data could be recorded into memory.
Press “REC” key to record the data, press once to record
another one till the memory is full. When the data is
recorded, “REC” mark is displayed at the Upper-Right
corner. If the memory is full, data will not be recorded
into the memory and “REC” mark will not be displayed.
Data can be recorded after it is cleared.
“T1 T2/T1-T2/ ” Button
Press “T1”, “T2”, “T1-T2” key to select input mode
T1, T2 or T1-T2. The input selection indicates which
input is selected for display. T1 thermocouple, T2
thermocouple or the differential between the two
thermocouples(T1-T2), when the thermocouple is turned
on, it is set to T1.