Amprobe AMB-50 Insulation-Resistance-Tester - Manual (Page 18)

12
• Turn the Meter to OFF when it is not in use.
• Take out the battery when it is not using for a long time.
• Do not use or store the Meter in a place of humidity, high temperature, explosive,
inflammable and strong magnetic field.
• If the Meter is wet, dry it before use.
� WARNING!
• Do not attempt to repair or service your Meter unless you are
qualified to do
• Bring this line up.This is one sentenceso and have the relevant calibration, performance test,
and service information.
Replacing the Battery
� WARNING!
To Avoid Electric shock, remove all the test leads from the Meter replacing the batteries.
� OPERATING CAUTION!
• Don’t mix old and new batteries.
• Make sure the polarity is correct when installing batteries.
• Do not use the Meter if the battery indicator ( ) shows a battery empty condition
• Do not carry out measuring with the battery compartment is open.
Follow the shown picture and proceed as follows to replace the battery:
• Turn the Meter to OFF and remove all connections from the terminals.
• Remove the screw from the battery compartment, and separate the battery
• compartment from the case bottom.
• Replace with 6pcs of new 1.5V (LR14) batteries.
• Rejoin the case bottom and battery compartment, and reinstall the screw.