Amprobe AMP-25 - Manual (Page 20)

16
Except for the replacement of the battery, repair of the
meter should be performed only by a Factory Authorized
Service Center or by other qualified instrument service
personnel.
The front panel and case can be cleaned with a mild
solution of detergent and water. Apply sparingly with a
soft cloth and allow to dry completely before using. Do
not use aromatic hydrocarbons, gasoline or chlorinated
solvents for cleaning.
BATTERY REPLACEMENT
When battery voltage drops below the value required for
proper operation, the battery symbol (
) appears.
W Warning
To avoid shock, injury, or damage to the Meter, disconnect
test leads before opening case.
Replacing BATTERY follow below steps:
1. Remove the Meter from measuring circuit.
2. Turn the Meter to OFF position.
3. Remove the screw from the battery cover and open
the battery cover
4. Remove the batteries and replace with two 1.5 V
batteries (LR44). Observe correct polarity when
installing the batteries.
5. Put the battery cover back and re-fasten the screw.
Battery: 2 x 1.5 V (LR44)