Installing the acceleraid 160 into a 2u chassis, Installing the acceleraid 160 into a 2u chassis -9 – Avago Technologies AcceleRAID 160 User Manual
Page 21
Advertising
Hardware Installation
Manual No. DB11-000021-00
9
Installing the AcceleRAID 160 into a 2U Chassis
You may need to check the manufacturer’s installation instructions for your
particular 2U chassis.
Caution
Be sure to wear a ground wrist strap at all times.
☛
Note
If the controller has the Standard PCI bracket
attached, replace it with the Low Profile PCI bracket
for this installation.
1. Choose the riser adapter with an available PCI slot. In this case, it is
presented on an angle, as shown in Figure 9.
2. Plug (install) the controller board firmly into the 32-bit PCI slot, and
snap it into place, as shown in Figure 9.
Figure 9. Plug the Controller into a 32-bit PCI Slot on the 2U Chassis
Advertising