Caution – Avago Technologies AcceleRAID 160 User Manual
Page 22
Advertising
Performing an Installation
10
AcceleRAID 160 Quick Installation Guide
In the finished installation, the controller will be in a flat, horizontal
position, as shown in Figure 10.
Figure 10. AcceleRAID 160 Installed into a 2U Chassis
3. Set the SCSI ID on each internal drive to a unique address between
0 and 15, but do not use address 7, as it is reserved for the controller.
See the documentation that comes with your drives for instructions on
how to set the SCSI ID address.
Caution
If internal and external drives are used, be sure that
drive addresses are NOT duplicated. External SCSI
cabinets usually automatically assign drive addresses
according to the drives’ location in the cabinet.
32-Bit PCI
Low Profile
Bracket
AR160
Advertising