EMC QLogic User Manual
Page 49
3
Configuring a Symmetrix Boot Device
3-13
Configuring an EMC Boot Device
there, you can configure your zone(s) on the fabric to allow the HBA
to connect to the array properly.
Procedure to Install Windows Server 2003 on a Fibre Channel Disk (Only for system
with floppy disk drive).
1. Boot with Windows Server 2003 Setup Media (See Microsoft
Documentation for details).
2. Monitor the white bar on the bottom of the screen.
3. Press
F6
within 5 seconds when the
ress F6 if you need to
install a third party SCSI or RAID driver
message is
displayed.
4. When the message
Setup could not determine the type of
one or more mass storage devices installed in your
system, or you have chosen to manually specify an
adapter.
is displayed, insert the QLogic driver diskette.
5. Follow the remaining instructions as displayed to complete the
Windows Server 2003 installation.
QLogic_Windows.book Page 13 Thursday, March 10, 2005 10:31 AM