EMC QLogic - Manual (Page 90)

4
4-16 EMC Fibre Channel with QLogic HBAs in the Windows Environment
Installing and Configuring the QLogic QLA4010 iSCSI HBA (TOE)
17. Press ESC to return to the Configuration Settings dialog.
18. Press ESC again, and you will be prompted to save changes.
Select Save changes, and press ENTER .
19. Select Configuration Settings again, and press ENTER .
20. Select iSCSI Boot Settings, and press ENTER .
21. To scan for your boot port, you can press enter on the primary
boot device at the top of the Boot Settings dialog. The HBA will
scan for targets and display them. If more than one target port is
located, it will be displayed. It is helpful to know the IQN of your
target port in order to select the correct target at this point. Select
the target IQN of your target, and press
ENTER .
22. The HBA will display the available LUNs under the selected
target port. Select the LUN that you wish to boot from, and press
ENTER . You may need to use the P AGE D OWN button to locate your
boot LUN.
23. If you have an alternate boot target configured, repeat steps
above to select the boot LUN for the alternate boot device.
24. When all boot LUNs have been selected, press ESC until you are
prompted to save your changes. Once saved, the iSCSI HBA is
ready to boot from the external array. Press
ESC at the Fast!UTIL
Options menu to reboot the host.
Installing the Windows OS onto the Boot Device
Follow the appropriate steps below to install the Windows operating
copy the latest QLA4010 driver to a floppy disk for use during the
installation procedure.
1. Boot the server with Windows 2000/2003 installation CD-ROM.
The server displays the following message, followed by a blank
blue screen.
Setup is inspecting your computer’s hardware configuration…
Press F6 as soon as the blue screen appears. Pressing F6 tells the
Windows installer that you want to load a third-party driver
before proceeding with the installation.
2. Setup will begin loading necessary drivers for installation.
Eventually, a dialog message will tell you that the setup program
cannot determine the type of one or more mass storage devices.
QLogic_Windows.book Page 16 Thursday, March 10, 2005 10:31 AM