PLANET UMG-1000 - Manual (Page 89)

89
Appendix A – Console Maintenance Mothod
The UMG-1000 Series has a built-in command line interpreter and provides users a
Command Line Interface (CLI). You can configure the network parameters by entering
commands from the CLI.
Please use the RJ-45 to RS-232 console cable that boundled in package. To connect the
RJ-45 port with Console port of UMG-1000, and connect another side (RS-232) with your
PC.
You can access the CLI from a VT-100 terminal or terminal emulator connected to the DB9
serial port or through a Telnet session. The UMG-1000’s serial port is EIA RS-232C
compliant with the interface parameters:
Baud rate
115,200
Number of data bits
8
Parity
None
Number of stop bits
1
Flow control No
To input the default account to login console mode: admin / admin
The bleow are the available command:
Command Description
Ifm get lan config To show the current LAN port network parameters
Ifm get wan config To show the current WAN port network parameters
Ifm set lan ip <string>
To set the LAN IP address
For example:
ifm set la nip 192.168.1.1
system reboot To reboot system
System reset to default To reset the system to factory default
?
To show all of available command