ProSoft Technology 5202-DFNT-DFCM4 - Manual (Page 53)

DFCM ♦ ProLinx Gateway Reference
DF1 Master/Slave Driver Manual
ProSoft Technology, Inc. Page 53 of 88
October 15, 2010
8.3 DF1 Configuration Error Word
DF1 Configuration Error Word errors are stored in protocol-specific registers. The
following table lists the Port/Register Address configuration.
DF1 Port Configuration Error Word Register
0 6307
1 6707
2 7107
3 7507
A register containing a code indicates a problem with the configuration. The
following table lists the codes, a description of the problem, and parameters to
correct the error condition within the configuration file.
Bit Code Description
0 0x0001 Invalid Enabled parameter (Yes or No)
1 0x0002 Invalid RS-Interface parameter (0 to 2)
2 0x0004 Invalid Type (Master or Slave)
3 0x0008 Invalid Protocol (RTU or ASCII)
4 0x0010 Invalid Baud Rate
5 0x0020 Invalid Parity (None, Odd, Even)
6 0x0040 Invalid Data Bits (7 or 8 bits)
7 0x0080 Invalid Stop Bits (1 or 2)
8 0x0100 Invalid Use CTS Line (Yes or No)
9 0x0200 Retry Count Invalid (0 to 10)
10 0x0400 Invalid Floating Point Data:
Float Flag not Yes or No
Float Start less than 0 or
Float Offset is Invalid
11 0x0800 Invalid Internal Slave ID (1 to 255) (Slave Only)
12 0x1000 Invalid Entry for Register Offset Data (Slave Only)
13 0x2000 Reserved
14 0x4000 Reserved
15 0x8000 Reserved