Sony MHC-V11 - Manual (Page 22)

22
GB
MHC-V11.4-582-493-21(1)
Pairing this system with
a BLUETOOTH device
Pairing is an operation where
BLUETOOTH devices register with each
other beforehand. Once a pairing
operation is performed, it does not
need to be performed again.
If your device is an NFC-compatible
smartphone, the manual pairing
procedure is not necessary. (See “One
Touch BLUETOOTH Connection by NFC”
(page 23).)
1
Place the BLUETOOTH device
within 1 meter (3 feet) from
the system.
2
Press BLUETOOTH on the
unit to select the BLUETOOTH
function.
“BT AUDIO” appears on the display.
Hints
• When there is no pairing information
on the system (for example, when you
use the BLUETOOTH function for the
first time after purchase), “PAIRING”
flashes on the display and the system
enters the pairing mode automatically.
In this case, proceed to step 4.
• If the BLUETOOTH connection is
established, terminate the BLUETOOTH
connection (page 23).
3
Hold down BLUETOOTH on the
unit for more than 3 seconds.
“PAIRING” flashes on the display.
4
Perform the pairing procedure
on the BLUETOOTH device.
For details, refer to the operating
instructions of your BLUETOOTH
device.
5
Select “MHC-V11” on the
display of the BLUETOOTH
device.
Note
If passkey is required on the BLUETOOTH
device, enter “0000.” “Passkey” may
be called “Passcode,” “PIN code,” “PIN
number,” or “Password.”
6
Perform the BLUETOOTH
connection on the
BLUETOOTH device.
When pairing is completed and
the BLUETOOTH connection is
established, “BT AUDIO” appears on
the display.
Depending on the BLUETOOTH
device, connection may start
automatically after pairing is
completed.
Notes
• You can pair up to 8 BLUETOOTH devices.
If the 9th BLUETOOTH device is paired, the
oldest paired device will be deleted.
• If you want to pair with another
BLUETOOTH device, repeat steps 1 to 6.
To cancel the pairing operation
Press BLUETOOTH on the unit.
Erasing all the pairing
registration information
To erase all the pairing registration
information, the system should
be reset to the factory default
settings. See “Resetting the system”
(page 37).