Sony MHC-V11 - Manual (Page 32)

32
GB
MHC-V11.4-582-493-21(1)
Changing information on
the display
You can view information, such as
track number, file/folder name, album
name and artist name.
Press DISPLAY repeatedly when
the system is on.
Notes on the display information
• Characters that cannot be displayed
appear as “_”.
• The following are not displayed;
— total playing time for an MP3 disc and a
USB device.
— remaining playing time for an MP3/
WMA file.
• The following are not displayed correctly;
— elapsed playing time of an MP3/WMA
file encoded using VBR (variable bit
rate).
— folder and file names that do not follow
either the ISO9660 Level 1/Level 2 in
the expansion format.
Using the Sleep Timer
The system turns off automatically
after the preset time.
Press SLEEP repeatedly to select
the desired time.
To cancel Sleep Timer, press SLEEP
repeatedly to select “OFF.”
Note
When opening and closing the disc tray, the
remaining time before the system turns off
may be extended.
Hints
• To check the remaining time before the
system turns off, press SLEEP.
• If you select “AUTO,” the system
automatically turns off after the current
disc or USB device playback ends, or
within 100 minutes.
Deactivating the buttons
on the unit (Child Lock)
You can deactivate the buttons
on the unit (except ) to prevent
misoperation, such as child mischief.
Hold down DJ OFF and  on the
unit for more than 3 seconds.
“LOCK ON” appears on the display.
You can only operate the system using
the buttons on the remote control.
To turn off the Child Lock function,
hold down DJ OFF and  on the
unit for more than 3 seconds until
“LOCK OFF” appears on the display.
Setting the automatic
standby function
By default, this system is set to turn
off automatically in about 15 minutes
when there is no operation or audio
signal output.
To turn off the function, hold
down
 while the system is
on, until “AUTO STANDBY OFF”
appears on the display.
To turn on the function, repeat the
procedure until “AUTO STANDBY ON”
appears on the display.
Notes
• “STANDBY” flashes on the display before
entering standby mode.
• The automatic standby function does not
work in the following cases:
— during tuner function.
— when the Sleep Timer is activated.