Canon EOS 1300D - Manual (Page 107)

107
Sending Images to a Web Service
While connected, a picture cannot be taken even if the camera’s shutter
button is pressed.
RAW images cannot be sent.
When sending an image to a Web service other than CANON iMAGE
GATEWAY, a send error message may not be displayed even if the
image was not sent to the Web service successfully. Such errors can be
checked on the CANON iMAGE GATEWAY site; check the error content,
then try sending the image again.
Depending on the Web service, the number of images that can be sent
and the length of movies will be limited.
You can select up to 50 files at a time. You can select and send up to 10
files at a time to YouTube.
When you reduce the image size, all images to be sent at the same time
are resized. Note that movies or still photos that are smaller than b size
are not reduced.
[Resize:S2] is enabled only for still photos shot with cameras of the
same model as this camera. Still photos shot with other models are sent
without resizing.
When accessing CANON iMAGE GATEWAY from a computer or other
device, you can check the send history for the Web services that the
images were sent to.
To terminate the connection without sending an image, press the
<M> button on the screen for step 1.
When you use a battery to power the camera, make sure it is fully
charged.
The camera’s <k> lamp will blink rapidly when data is being sent.