Eiki LC-WB40N - Manual (Page 31)

1
Computer Input
Choose Computer 1(Digital) by pressing the INPUT button
on the top control or press the COMPUTER button on the
remote control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Press the MENU button to display the On-Screen
Menu. Use the Point 7 8 buttons to move the red
frame pointer to the Input Menu icon.
1
Input Menu
Use the Point ed buttons to move the red arrow
pointer to Computer 1 (Digital), and then press the
SELECT button.

After the Source Select Menu appeared for Computer
1 (Digital), move the pointer to RGB (PC digital) or
RGB (AV HDCP), and then press the SELECT button.

Input Source Selection (RGB(PC digital), RGB(AV HDCP))
Move the pointer
(red arrow) to
Computer 1
(Digital) and press
the SELECT button.
Input Menu icon
Move the pointer to
the source that you
want to select and
press the SELECT
button.
Computer
1
Computer 1 (Analog)
Video
Computer 
COMPUTER button
Wired
Top Control INPUT button
Computer 1 (Digital)
Remote Control
Computer 1 (Analog)
Computer 
Computer 1 (Digital)
Direct Operation
Menu Operation
✔
Notes:
• HDCP (High-bandwidth Digital Content Protection) is
a system for protecting digital entertainment content
delivered by DVI (Digital Visual Interface) from being
copied. The specification of HDCP is decided and
controlled by Digital Content Protection, LLC. Should the
specification be changed, this projector may not display
the digital content protected by HDCP.
• Wired and Wireless are for the Network function. See
owner’s manual “Network Set-up and Operation” .
• When the Input Search function is set to “On1” or “On2”,
the input signal will be searched automatically (p.51).
Wireless