Antitheft alarm function – Eiki LC-WB40N User Manual

Page 60

Advertising
background image

60

Antitheft Alarm Function

Charge the built-in batteries

Set the Battery charge option in the Alarm setting menu to

“Auto.” The default setting is “Auto.”

As long as the AC power cord is connected and this option

is set to “Auto,” the built-in battery for Alarm function is being

charged at all times. While charging the battery, “Charging” is

displayed in the menu.

The “Charging” appears dimmed when the battery is fully

charged or the Battery charge option is set to “Off,” or if

charging malfunction occurs. Set the option to “Off” when

not using the Alarm function. This can save the power and

battery life.

Note:

• The PIN code and settings you have changed are effective even after

the battery is changed.

• Unplug the battery connector if you carry your projector frequently

and use the carrying case. If you do not unplug the battery connector,
the alarm may be triggered when the Alarm buttons are accidentally
pressed inside the carrying case.

Remove the screw and

open the battery cover.

Install the battery, then put back the battery cover

and secure it with the screw.

Screw

Replace the rechargeable batteries

Use only the specified battery for this projector. Using other

types of battery may cause accident or fire hazard.

Replacement Battery: SANYO Ni-MH BATTERY PACK

Part No. 645 089 8587

How to replace the rechargeable batteries

Unplug the AC power cord from a wall outlet.

1


Set the Alarm function to “Off” (see page 58). If it is not

released, the alarm will start ringing when you try to

remove the rechargeable battery cover.
Remove the screw from the rechargeable battery cover

and open the cover.



Pull out the battery connector and remove the battery.

4

Install new battery and plug the connector into the

socket.

Note: The battery connector has polarity. Observe

battery polarity when installing.

5

Put back the battery cover and secure it with the screw.

Caution: Tighten the screw securely. If you fail to do

so, the alarm will not operate. Do not use any

other screws. This may cause damage to the

projector.

6

Advertising